Description: iCE40 family of devices do not support HiSPI to Parallel Sensor Bridge Reference Design. Instead the Lattice MachXO2 family can be considered for this functionality. Link to Single HiSPi sensor bridge design using XO2: ...
With the reference design UG36-- "HDMI/DVI Interface", we provide raw data signals "rx_ade/rx_audio_ch0[3:0]/rx_audio_ch1[3:0]/rx_audio_ch2[3:0]". The user may get audio data by decoding the signals according to HDMI specification. To output audio ...
No. The current reference design, RD1097, supports only the resolutions between 1024x768@60Hz(65MHz pixel frequency) to 1600x1200@60Hz(162MHz pixel frequency). You can get detailed information from Table 6 and Table 7, RD1097.
The word alignment function in PCS is use to catch the 4 dedicated commas. The HDMI data codec format is not the real G8B10B, one internal word alignment module was used to make the function more robust. With the improvement of the internal word ...
Yes. Some settings of Serializer-Deserializer (SerDes) are adjusted through Serial Communication Interface (SCI) to support more resolutions low up to 800x600@60Hz. "10B only" mode is used in SERDES for our High Definition Multimedia Interface/ ...
The IP does not directly support 2K formats. However, you can define 2K as a custom standard in the IP GUI. Then the IP will support it. The format detection part of the receiver does not identify the stream as 2048x1080, instead, it identifies all ...
The DSI-RX Reference Design (RD1185) supports all video transmission modes defined in the MIPI DSI Specification v1.1: - Non-Burst Mode with Sync Pulses - Non-Burst Mode with Sync Events - Burst mode The DSI-TX Reference Design (RD1184) supports two ...
Lattice Technical Support Expectation Please be advised that highest priority for Lattice Technical Support will be given to 1. Software which is not working as expected or suspected bugs. We recommend that customers use the latest software tools and ...
Lattice currently recommends the following for implementing Gigabit Ethernet interfaces: CertusPro-NX FPGAs: Use SERDES-based SGMII or RGMII Certus-NX, MachXO5-NX, and CrossLink-NX: Use RGMII These recommendations are based on updated LVDS-based ...
Glitch Fliter is used to prevent short-duration events of glitches, This is used to prevent False tripping on noise in a system. GLITCHFilter in device constraints , enables 1ns glitch filtering.
Description: Nexus device family has a default I2C slave address of 0x40 and you are allow to modify it based on your requirement. Solution: To permanently modify the I2C address, you can modify the desired value in .fea file and use the Programmer ...
Description: To understand the RTL formatting of the PCIe configuration space in the Nexus' PCIe demos, please refer to the following details. Figure 1 illustrates the initialization of the PCIe configuration space in the Nexus' demo.