To use UART for CrossLink-NX, we need to do the following: Hardware: 1. Remove I2C resistors, R20 and R21, on the evaluation board. 2. Connect a 0-ohm resistor, R15 and R17, for the UART connection on the evaluation board.
We do not have adaptor to connect J6 header. Also MIPI interface through J6 has not tested. However, by looking at the datasheet of the header pin, Wurth part number: 61302021121 (url: ...
Description: The customer has observed discrepancies between the design recommendations provided in the Hardware Checklist and the actual design implementation on the Lattice Evaluation Board. Reason: Hardware Checklists are developed after ...
Please use documentation on CrossLink Rev C for your customers who are using Rev D. Generally, the change is just an improvement of the circuit layout on the board in order to remove the wire jumper that is present in Rev C and implement in Rev D. ...
Description: The "aaa" characters are unused for Crosslink devices but might be used for other devices (i.e., Crosslink-NX). These "aaa" characters are only added to comply with the 20 characters of the naming convention.