5915 - CrossLink: Where can I find documentation about Master Link board Rev D?
Please use documentation on CrossLink Rev C for your customers who are using Rev D.
Generally, the change is just an improvement of the circuit layout on the board in order to remove the wire jumper that is present in Rev C and implement in Rev D. Nonetheless, they are the same in function.
Related Articles
5598 - Where can I find the dimension for mounting holes on LIF-MD6000 evaluation board?
For the mechanical drawing of the LIF-MD600 MasterLink Board, please proceed on the link below. http://www.latticesemi.com/en/Products/DevelopmentBoardsAndKits/CrossLinkLIFMD6000MasterLinkBoard Under Documentation table, select 'Design File' under ...
7748 - Why is there a mismatch between the hardware checklist and the evaluation board circuit design?
Description: The customer has observed discrepancies between the design recommendations provided in the Hardware Checklist and the actual design implementation on the Lattice Evaluation Board. Reason: Hardware Checklists are developed after ...
6893 - How can I use CrossLink-NX evaluation board for UART communication?
To use UART for CrossLink-NX, we need to do the following: Hardware: 1. Remove I2C resistors, R20 and R21, on the evaluation board. 2. Connect a 0-ohm resistor, R15 and R17, for the UART connection on the evaluation board.
7030 - Crosslink-NX: Do you have any connector board which can be connected to the J12 of VVML board?
There's no available connector board for this.
5615 - Crosslink: Is the pin-out for the LIA-MD6000-81 identical to the pinout for the LIF-MD6000-csfBGA81? I can download the Excel pinouts for the 'LIF' Crosslink family, but I cannot find separate documentation for the Crosslink Automotive device.
For the pinout information of automotive parts, you may check FPGA-DS-02013, link: http://www.latticesemi.com/view_document?document_id=51753 They are of the same pinout information for LIF variants which is described in FPGA-DS-02007, link: ...