5615 - Crosslink: Is the pin-out for the LIA-MD6000-81 identical to the pinout for the LIF-MD6000-csfBGA81? I can download the Excel pinouts for the 'LIF' Crosslink family, but I cannot find separate documentation for the Crosslink Automotive device.
For the pinout information of automotive parts, you may check FPGA-DS-02013, link: http://www.latticesemi.com/view_document?document_id=51753
They are of the same pinout information for LIF variants which is described in FPGA-DS-02007, link: http://www.latticesemi.com/view_document?document_id=51662.
This information is matched with the pinout found in the Excel sheet file.
Related Articles
5598 - Where can I find the dimension for mounting holes on LIF-MD6000 evaluation board?
For the mechanical drawing of the LIF-MD600 MasterLink Board, please proceed on the link below. http://www.latticesemi.com/en/Products/DevelopmentBoardsAndKits/CrossLinkLIFMD6000MasterLinkBoard Under Documentation table, select 'Design File' under ...
6305 - MachXO: Where to find the automotive BSDL files?
The automotive BSDL files for MachXO should be the same functionality as the standard device files on the website.
5915 - CrossLink: Where can I find documentation about Master Link board Rev D?
Please use documentation on CrossLink Rev C for your customers who are using Rev D. Generally, the change is just an improvement of the circuit layout on the board in order to remove the wire jumper that is present in Rev C and implement in Rev D. ...
4076 - ECP5: While migrating device pinout from LatticeECP5-25 to LatticeECP5-85 device, how to handle the pins when some pins are notified as NC in LatticeECP5-25 and GND or RESERVED in LatticeECP5-85 device?
When migrating the device pinout from LatticeECP5-25 to LatticeECP5-85 devices, generally, the NC pins in LatticeECP5-25 pinout can be notified as GND or RESERVED pins in LatticeECP5-85. If the LatticeECP5-85 pins are notified as GND, then you can ...
729 - IBIS Model: How do I find the output resistance of an I/O?
An IBIS Model is a mapping of voltage to current values for a given I/O standard, slew rate, and drive strength. User can estimate the output resistance by using a simple slope formula, in relative to the flow of current. Using Ohm's law: Resistance ...