6084 - CrossLink-NX: Do we have adaptor to connect for MIPI DPHY Connector on CL-NX-Evaluation Board?
We do not have adaptor to connect J6 header. Also MIPI interface through J6 has not tested. However, by looking at the datasheet of the header pin, Wurth part number: 61302021121 (url: https://www.we-online.de/katalog/en/PHD_2_54_THT_DUAL_PIN_HEADER_6130XX21121#61302021121), the contact resistance is 20 m-ohm. This is relatively small and can handle high-speed signal. The speed should not degrade too much voltage through FMC.
Related Articles
6893 - How can I use CrossLink-NX evaluation board for UART communication?
To use UART for CrossLink-NX, we need to do the following: Hardware: 1. Remove I2C resistors, R20 and R21, on the evaluation board. 2. Connect a 0-ohm resistor, R15 and R17, for the UART connection on the evaluation board.
7748 - Why is there a mismatch between the hardware checklist and the evaluation board circuit design?
Description: The customer has observed discrepancies between the design recommendations provided in the Hardware Checklist and the actual design implementation on the Lattice Evaluation Board. Reason: Hardware Checklists are developed after ...
7030 - Crosslink-NX: Do you have any connector board which can be connected to the J12 of VVML board?
There's no available connector board for this.
6135 - Crosslink-NX: What is the difference between the Crosslink-NX evaluation boards LIFCL-40-EVN and LIFCL-40-EVNG?
LIFCL-40-EVN and LIFCL-40-EVNG are the same boards. The added G on the part number is just an internal classification but rest assured that all of its features and functions are all the same.
1747 - LatticeECP3: What are the mechanical positions of the mounting holes and J58 pin A1 on the LatticeECP3 IO Protocol Evaluation Board?
For the Rev C version of the LatticeECP3 IO Protocol evaluation board, the mounting hole positions are at: (0.000, 7.606) - upper left (3.460, 5.940) - upper center (7.606, 7.606) - upper right (0.000, 0.000) - lower left (5.000, 2.040) - lower ...