6135 - Crosslink-NX: What is the difference between the Crosslink-NX evaluation boards LIFCL-40-EVN and LIFCL-40-EVNG?
LIFCL-40-EVN and LIFCL-40-EVNG are the same boards.
The added G on the part number is just an internal classification but rest assured that all of its features and functions are all the same.
Related Articles
7748 - Why is there a mismatch between the hardware checklist and the evaluation board circuit design?
Description: The customer has observed discrepancies between the design recommendations provided in the Hardware Checklist and the actual design implementation on the Lattice Evaluation Board. Reason: Hardware Checklists are developed after ...
6893 - How can I use CrossLink-NX evaluation board for UART communication?
To use UART for CrossLink-NX, we need to do the following: Hardware: 1. Remove I2C resistors, R20 and R21, on the evaluation board. 2. Connect a 0-ohm resistor, R15 and R17, for the UART connection on the evaluation board.
1613 - Where can I find detailed information about the Lattice evaluation boards?
The Detailed information of any Lattice Evaluation Board, For example: Theory of Operation, Configuration and Programming, Schematic etc are available in the respective Evaluation Board User's Guide/ User's Manuals. To get the User's Guide or User ...
6084 - CrossLink-NX: Do we have adaptor to connect for MIPI DPHY Connector on CL-NX-Evaluation Board?
We do not have adaptor to connect J6 header. Also MIPI interface through J6 has not tested. However, by looking at the datasheet of the header pin, Wurth part number: 61302021121 (url: ...
6567 - Crosslink: What is the meaning of "aaa" characters in the Crosslink IBIS model?
Description: The "aaa" characters are unused for Crosslink devices but might be used for other devices (i.e., Crosslink-NX). These "aaa" characters are only added to comply with the 20 characters of the naming convention.