5988 - Lattice Diamond : Error on Synthesis RD1182 : The flow errors out because "aligner_4_on_on" is unexpanded. What is the workaround.
Solution:
1. Directory „rd1182_mipi_dphy_interface_ip\rd1182\source\verilog\ecp5\ngo“
Copy "aligner_4s_on_on.ngo“ to "aligner_4_on_on.ngo“
2. Strategy -> LSE -> change Macro Search Path to
[Path]/rd1182_mipi_dphy_interface_ip/rd1182/source/verilog/ecp5/ngo
3. Strategy -> Translate Design -> change Macro Search Path to
[Path]/rd1182_mipi_dphy_interface_ip/rd1182/source/verilog/ecp5/ngo
[Path] is the local path where the RD was unzipped.
Related Articles
6968 - Tri-speed Ethernet MAC: How to resolve Tri-speed Ethernet MAC version 1.4.0 synthesis error?
Description: Following error is encountered when compiling Radiant project with Tri-speed Ethernet MAC IP version 1.4.0, which is due to invalid .ldc file constraint: Error 1026000 Synthesis ERROR - ...
356 - In Lattice parts with SERDES/PCS, how can I control the word aligner using my own FPGA-based link state machine ?
You can use the word_align_en_[0-3]/ffc_enable_cgalign_ch[0-3] either in an 8b10b based or 10-bit SERDES only based mode. The simulation waveforms below shows how a low pulse on the word_align_en_0 (LatticeSC/LatticeECP3 signal that has same function ...
1675 - LatticeECP3: Why does ispLEVER & Lattice Diamond Place and Route generate errors
when I assign DDR3 Address or Command output signals to DQS pins?
For DDR3, the Address & Command outputs are generated using the DDR registers(ODDRXD1 modules). The DQSP and DQSN pins do not support DDR registers hence the error. These outputs will need to be assigned to non-DQS pins. Please see section "DDR3 ...
5809 - MIPI: What workaround to use when Single Ended inputs in Bank 1/2 when Soft D-PHY is assigned to a bank?
To workaround this is to use the MIPI primitive to allow a pseudo LVCMOS12 interface: MIPI LVSD12_inst0 ( .AP (1'b0), .AN (1'b0), .HSSEL (1'b0), .TP (1'b1), .TN (1'b1), .OLSP (int_a), .OLSN (int_b), .OHS (), .BP (pin_a), .BN (pin_b)) /* synthesis ...
214 - PCS Simulation: Iteration Limit Error
Description: An iteration limit error may appear when simulating using the PCS IP core. Solution: There are several possible causes for the Iteration Limit Errors. The polarities of the PCS resets are incorrect. When the SERDES Quad reset is removed, ...