1977 - Do I need to purchase "28-pin converter" to program a Lattice Device with my Model 300 Programmer?
Lattice provides a wide array of adapters for programming Lattice products via a desktop programmer from Lattice or 3rd party vendor.
A 28-pin converter (Lattice Part Number "pDS4102N-28P2SAB") is required for use with Lattice socket adapters only if Lattice-approved 3rd party desktop programming hardware is used. For the Lattice Model 300 programmer and the Lattice Socket adapter, the "28 pin converter" is not required.
Every Lattice socket adapter features an interface at the bottom to a standard 28-pin socket. The top of the socket adapter is specific to a Lattice device package type. Programming signals from the Model 300 programmer are routed to the appropriate device programming pins via the socket adapter.
Please find the document on Lattice Socket Adapters for more details on adapters to program a Lattice device.
Related Articles
2264 - Model 300 Programmer: What is the procedure to program a generic JTAG device using SVF Files and Model 300 Programmer?
The Model 300 Programmer can program any generic JTAG device, provided user have the correct SVF file for it. User can program any JTAG device that has a SVF file by selecting the correct adapter footprint and voltage in the Model 300 Programmer main ...
6238 - Lattice Programmer Tool: How to program Lattice FPGA using Programmer?
1. Open Lattice Radiant/Diamond Programmer. 2. Detect the programming cable: -Click "Detect Cable" on most right corner, then choose the first port if you are using only 1 FTDI USB cable. The sequence always starts at 0 which is the allocated address ...
Radiant Programmer: What is Erase, Program, Verify Quad 1 operation used for?
Description: Erase, Program, Verify Quad 1 enables that QE bit to '1'. In general, there are two (2) requirements/steps to enable booting from external SPI Flash through x4 (QUAD Mode) Step 1 - Convert the bitstream file into hex (Quad I/O read mode) ...
2514 - MachXO2/MachXO3: What is the best way to program a Lattice MachXO2 device in the field with minimum disruption?
Solution: The Lattice MachXO2 devices can be updated in the field by utilizing Lattice's background programming mode and TransFR Technology Background programming: The on-chip flash can be programmed in background mode, while the device and IOs ...
5248 - Crosslink: How to program the CrossLink through I2C with Lattice Diamond Programmer and Lattice HW-USBN-2B download cable or MCU-based I2C programming using I2CEMBEDDED?
The CrossLink device is programmable using SPI or I2C. Thus, the programming is supported through: 1. SPI/I2C-based embedded programming (SSPIEMBEDDED or I2CEMBEDDED) using an Embedded MCU, or 2. SPI/I2C operations through Lattice Diamond Programmer ...