6207 - CertusPro-NX: How to inject a soft error using Radiant?

• Related Articles

• 6984 - MachXO5-NX Development Board: How to access the MachXO5-NX Development Board via SSPI using onboard FTDI?

  To access the MachXO5-NX Development Board via SSPI using the onboard FTDI, the user should follow the steps as described below. 1.) The MachXO5-NX Development Board Setup is shown below.

• 6584 - CertusPro-NX: Does sedc_err_o and sedc_errm_o implementation of 'sticky' functionality in the Silicon itself or in some soft logic?

  Description:sedc_err_o and sedc_errm_o are implemented with "sticky" functionality. "Sticky" functionality is defined as functionality where in the setting persist even through reset. The implementation of sticky bit is implemented in Silicon.

• 7070 - MachXO5-NX: How to perform Dual-Boot using MachXO5-NX?

  See below for steps on how to perform Dual-Boot in MachXO5-NX Background: The current implementation of Dual-Boot is that the JUMP table is found at Address 0.

• 6291 - CertusPro-NX: Can we use SED/SEC with “sedc_cof_i = 1” for production?

  Definition: Yes, the set sedc_cof_i can be set to high or 1 for production. In this manner, the SED/SEC flow will continue to the next frame even error has been detected. In the scenario that sedc_cof_i is low, it will stop SED/SEC when ...

• 7063 - Radiant 2023.1 and SEDC: How to use SEDC properly with reveal?

  Description: When observed at Reveal for CrossLink-NX using SoftJTAG, a timing error occurs. Solution: When using reveal with SEDC make sure that no distributed RAM is used for both Trace Signal Setup and Trigger Signal Setup like below: