1040 - Lattice Programming Cable: Does Lattice Programming Cable works with Parallel Port Conversion Adaptor?
Lattice does not encourage the use of port conversion adaptor (for example: USB to Parallel port convertor) and unable to guarantee the functionality of Lattice Programming Cable will operation as intended, if such adaptor was used.
In any case, please use the Lattice programming cable without going through any additional medium in between cable and host PC.
Related Articles
2183 - Does the Lattice DL2A Parallel Port download cable use an off-the-shelf RJ45 cable?<br>
Solution: The DL2A cable uses a custom cable that has an RJ45 style crimp connector on one end. The cable can not be replaced with an off-the-shelf RJ45 network cable.
2081 - Diamond: Where can I find the driver for Lattice USB programming cable in Lattice Diamond ?<br><br>
Solution: Assuming default installation directory for Lattice Diamond , the driver for Lattice USB programming cable can be found at: C:\lscc\diamond\3.x\data\vmdata\drivers\lscusbdriver\x86 (for Intel machine) The changes in files and directory ...
891 - Do user needs to connect all wires from Lattice Programming Cable to an evaluation board?
When using the USB or parallel Programming Cables, user will typically connect the "flywire" signals: VCC, TDO, TDI, TMS, GND, and TCK. The other signals are optional connections that user may set checkboxes for in ispVM/Diamond/Radiant Programmer if ...
5248 - Crosslink: How to program the CrossLink through I2C with Lattice Diamond Programmer and Lattice HW-USBN-2B download cable or MCU-based I2C programming using I2CEMBEDDED?
The CrossLink device is programmable using SPI or I2C. Thus, the programming is supported through: 1. SPI/I2C-based embedded programming (SSPIEMBEDDED or I2CEMBEDDED) using an Embedded MCU, or 2. SPI/I2C operations through Lattice Diamond Programmer ...
Radiant Programmer: What is Erase, Program, Verify Quad 1 operation used for?
Description: Erase, Program, Verify Quad 1 enables that QE bit to '1'. In general, there are two (2) requirements/steps to enable booting from external SPI Flash through x4 (QUAD Mode) Step 1 - Convert the bitstream file into hex (Quad I/O read mode) ...