7090 - HW-USBN-2B: Why Lattice USB Programming cable is not working and the LED light is always on?

• Related Articles

• 3580 - HW-USBN-2A: What is the country of origin for the Lattice Cable HW-USBN-2A?<br>

  The country of origin for the Lattice Cable HW-USBN-2A is China.

• 5248 - Crosslink: How to program the CrossLink through I2C with Lattice Diamond Programmer and Lattice HW-USBN-2B download cable or MCU-based I2C programming using I2CEMBEDDED?

  The CrossLink device is programmable using SPI or I2C. Thus, the programming is supported through: 1. SPI/I2C-based embedded programming (SSPIEMBEDDED or I2CEMBEDDED) using an Embedded MCU, or 2. SPI/I2C operations through Lattice Diamond Programmer ...

• 6212 - Programmer: Is HW-USBN-2B compatible with the MACH4A5 (M4A5) family?

  The MACH4A5 is a 5V core device and cannot be programmed with an HW-USBN-2B cable. The HW-USBN-2B supports the programming of Lattice devices with a core voltage of up to 3.3V. Programming devices with a 5V core requires the HW-USBN-2A USB cable or ...

• 3875 - Programmer: What is the maximum programming frequency achieved with HW-USBN-2A cable, while programming MachXO2 device using Slave Serial Programming Interface (SSPI)?

  The maximum achievable Slave Serial Programming Interface (SSPI) programming frequency with HW-USBN-2A cable is 1.5 MHz, when the TCK value is either set to 0 or 1. For other values of TCK (2 to 10), the SSPI programming frequencies are listed below: ...

• 1040 - Lattice Programming Cable: Does Lattice Programming Cable works with Parallel Port Conversion Adaptor?

  Lattice does not encourage the use of port conversion adaptor (for example: USB to Parallel port convertor) and unable to guarantee the functionality of Lattice Programming Cable will operation as intended, if such adaptor was used. In any case, ...