Configuration / Programming / Security | SSPI

SSPI
7740 - How to enable SSPI programming in MachX03-9400 Development Board
Setup to enable SSPI in MachX03-9400 development board. Connect to JP2, MCLK, SI, SO, SS, 5V SPI, GND to USBN programming cable. Connect FTDI, do a JTAG chain scan, make sure JTAG can program. Connect USB programming cable. Set to Slave SPI ...
1422 - Can I configure the configuration SRAM memory with the Slave SPI Mode(SSPI)?
You can not configure the configuration SRAM memory directly with the Slave SPI Mode(SSPI), nor can you read back SRAM memory with the SSPI. But you can use the SSPI to configure the SRAM memory through a REFRESH instruction. The effect is the same ...

Configuration / Programming / Security | SSPI | Knowledge Base