Which power supplies are used by the PLL in Avant?

The VCCA_PLL* and VCC are the power supplies connected to the PLL power rails.

• Related Articles

• How to access the Nexus PLL configuration space register via APB2LMMI?

  One of the most common points of confusion stems from the updated address mapping in PLL version 1.9.0. Previously, the APB interface used a different width and offset scheme for accessing PLL registers. However, with the release of this version, the ...

• 6287 - ICE40 UltraPlus: Does any GBIN input pin can be used to drive the reference clock input to the PLL?

  Solution: Yes, Any GBIN pin can be used to drive the reference clock input to the PLL on iCE40. If the PLL instantiated, the the GPLL_IN dual mode cannot be used as input to other pins but could only be used as output pin. With this GPLL_IN pin, is ...

• 2491 - Is the PLL Lock time, Tlock, measured from power ramp up?

  The lock time of the PLL is not gated to power ramp up, it is dependent on the reset signal. After the FPGA is finished configuring, a global reset signal (GSR) is asserted to the chip prior to waking up and operating. PLL lock time, Tlock, is ...

• 1156 - How can I specify what type of PLL is used for a LatticeECP2/M FPGA?

  Beginning in version 7.1 of ispLEVER, the user can specify explicitly whether the software will create a GPLL or an SPLL for the LatticeECP2/M when creating the PLL using IPExpress. This is done with a radio style selector button under the Delay ...

• 3678 - PLL: When does the lock of PLL lose?

  Description: There could be several reasons for Phase Lock Loop (PLL) losing the lock. 1.If the input clock or feedback signals to the PLL become invalid. 2.If there is Noise in the PLL power supply. 3.If the input clock Period Jitter (tIPJIT) of the ...