Radiant Programmer: Does this support remote programming capability?
Radiant Programmer itself does not have the capability of doing remote programming, it will need a third-party connection to allow remote programming.
User can use their server as long as they have the 3rd party hardware component (hub) and software that acts as the bridge allowing USB remote connection to other computers via internet IP addresses.
So this is how it works:
1. Setup 3rd party SW drivers on the server and connect to a USB hub.
2. Connect the FPGA board to the USB Hub.
3. Connect the remote computer to the USB hub via the internet IP address. (the configuration on how to allow remote connection on the hub should depend on the 3rd-party SW that will be used)
4. Once the connection to the USB hub is established, the remote computer can now start programming using our Programmer by selecting the port connection of the hub.