Radiant: Is it recommended to check the initial timing report generated by Synplify Pro under the SRR file?

Customers should not be using the timing report generated by Synplify Pro. There is a warning on the Synplify Pro timing report to refer to the FPGA vendor place and route report. See the warning below:

 

Please use the timing report generated by Radiant either after the post-synthesis, map, or place-and-route (PAR) processes. 

• Related Articles

• 2353 - All FPGAs: What is the function of the Synplify Pro's option "Fix Generated Clocks"?

  Description: The option is used for the generated-clock conversion. i.e., its values are * 0 – does not convert * 1 – converts; does not report * 2 – converts; reports only sequential elements that could not be converted * 3 (default) – converts; ...

• All Devices: Why does 'set_multicycle_path -hold' constraint is not propagated to Synthesis using Synplify Pro FDC file?

  Description: The issue is present using Radiant 3.1.1 or below on any of the available FPGA devices on the tool. Solution: There is a work around using the Tcl console in the radiant GUI, or if you opt to use the tool from the command line it is even ...

• 7562 - Radiant: The synthesis design process does not complete when synthesis is run on Synplify Pro OEM

  In Radiant, the synthesis and post-synthesis processes are a combined process under "Synthesize Design". When you run synthesis using the standalone version of Synplify Pro, this version generates a .vm file which will be used to run post-synthesis ...

• Radiant / Synplify Pro: Why does Postsyn reject the user's pre-synthesis constraints on an FDC file when Reveal Inserter is included in the project?

  Description: The issue is caused by some differences in the behavior of the Verific and Synplify language parsers related to the handling of the escape characters in the instance name. Solution: This is not yet fixed by Synplify Pro and no timeline ...

• Diamond / Synplify Pro: Why is the Frequency for Synplify Pro Strategy Setting is set to 1 MHz when using the Area preset strategy?

  When selecting Area preset strategy, the Frequency setting on the Synplify Pro will change to 1 MHz. If the user changes Frequency setting this to a mid or higher value, the optimization will try to meet that higher frequency and therefore the area ...