7735 - Radiant 2024.2 and Diamond 3.14 Synplify Pro: BN161: Net has multiple drivers warning

• Related Articles

• 7285 - Synplify Pro on Diamond or Radiant: can't see compilation errors

  Description: In Diamond or Radiant when using Synplify Pro, there are instances where you are unable to see the error messages on the Message tab. Solution: This is an ongoing enhancement with Synopsys for Radiant and Diamond. This is estimated to be ...

• 7713 - Radiant Synthesis with Synplify Pro: results differ on multiple machines

  Description: When using Synplify Pro on different machines, the system environment could cause different behavior. Some symptoms of this issue include the following: 1. The synthesis behavior is different on another machine (e.g. passes or fails on a ...

• 6787 - Radiant: Is it recommended to check the initial timing report generated by Synplify Pro under the SRR file?

  Customers should not be using the timing report generated by Synplify Pro. There is a warning on the Synplify Pro timing report to refer to the FPGA vendor place and route report. See the warning below: Please use the timing report generated by ...

• 6894 - Diamond / Synplify Pro: Why is the Frequency for Synplify Pro Strategy Setting is set to 1 MHz when using the Area preset strategy?

  When selecting Area preset strategy, the Frequency setting on the Synplify Pro will change to 1 MHz. If the user changes Frequency setting this to a mid or higher value, the optimization will try to meet that higher frequency and therefore the area ...

• 6092 - Lattice Diamond Programmer: WARNING in Linux OS - Drivers were not detected. Install the Lattice VM Drivers to access the JTAG Chain.

  Description: In Lattice Diamond Programmer either standalone or from Diamond, user experience WARNING message in Linux OS as below. WARNING - Drivers were not detected. WARNING - Drivers were not detected. Install the Lattice VM Drivers to access the ...