6118 - Power Manager: Are LA-ISPPAC-POWR1014-01TN48E and ISPPAC-POWR1014-01TN48I programmable in the same JEDEC file?

• Related Articles

• 1159 - ispLEVER: Can ispVM System program ispClock or ispPAC-POWR products?

  Yes, ispVM System can be used to program ispClock or ispPAC-POWR devices. User will need to use Pac-Designer to create a JEDEC or Serial Vector Format (.SVF) file to program these devices with ispVM System. The JEDEC file can be created from the ...

• 270 - PAC-Designer: How to implement multiple ispPAC-POWR1220AT8 Power Manager devices on a board?

  Solution: There are several ways - in some cases the functions inside a Power Manager may be stand alone and not affect the other device controlling different supplies. In cases where there are zones or sections that need to get powered up and down, ...

• 6830 - MachXO5D: How is USERCODE stored in MachXO5 JEDEC file?

  The MachXO5 JEDEC file should not have the U Field (USERCODE) since the MachXO5 Flash didn't support it. The only USERCODE is supported for MACHXO5 is the SRAM USERCODE, which embedded into the bitstream and config data of the JEDEC files.

• 2119 - How can I use Test Access Port (TAP) Instructions for a Power Manager Device ?

  Solution: In a Power Manager Device an IEEE 1149.1 test access port (TAP) provides the control interface for serially accessing the digital I/O of the device. The TAP controller is state machine driven with mode and clock inputs. Given in the correct ...

• 2504 - Can I use same JEDEC file or bit file to program different speed rating parts?

  Solution: Speed rating will define some characteristics of the parts, like how fast the part can run, and if it is commercial or industrial part. So if you want to use same JEDEC or bit file to program different speed rating part, your timing ...