7029 - Lattice Radiant: Why are the directory paths in .sty defined as relative paths?

• Related Articles

• 7480 - Lattice Radiant: Why are there missing timing paths analyzed on R3.0 when it was compared with R3.1 and later?

  Description: When users try to compare timing analysis paths from R3.1 and later with R3.0, there are timing violations/timing paths found in R3.1 and later that cannot be found in R3.0. Solution: This is a known issue on Software version R3.0 The ...

• 7075 - Lattice Radiant/Diamond: Do I need to constrain internal paths found on Hard Blocks (Lattice primitives)?

  Timing within hard blocks are already optimized. Paths utilized in the primitive are already consistent hence Ideally there is no need to have them (the paths inside) constrained separately. Users would just need to connect the input/output ports to ...

• 6185 - Lattice Diamond and Radiant Programmer: Does Lattice Programmer software and driver support FT4232HQ?

  Both Lattice Diamond and Radiant Programmer are not support FT4232HQ.

• 6272 - Radiant: How to install Radiant via Linux Terminal only and without GUI?

  Radiant Linux installer supports console mode installation. See below usage: Usage: [options] Key=Value Options: -h, --help Displays this help. --console Starts the application as console mode. --prefix Inputs installation target directory. Example: ...

• 7734 - QuestaSim / ModelSim : How to use User-defined Radix?

  Solution: Normally, this appears gray by default. However, it is fully supported in QuestaSim / Modelsim Lattice Edition. To enable this, a User-defined Radix needs to be set first before this option is enabled. See the following command: radix ...