6035 - Lattice Radiant Programmer: Why after changing "Program Control NV Register 1" in Radiant Programmer, it cannot restore back to original value? 

• Related Articles

• 6185 - Lattice Diamond and Radiant Programmer: Does Lattice Programmer software and driver support FT4232HQ?

  Both Lattice Diamond and Radiant Programmer are not support FT4232HQ.

• 1226 - Radiant Programmer: What programmer detected Lattice device as "JTAG-NOP"?

  JTAP-NOP indicates that a device was detected, but its JTAG IDCODE is not available in software device database. There are a few reasons this may occur: 1. The device is a newer Lattice device and is not yet supported by the software tool version ...

• 6451 - Lattice Diamond: What does the [31:0] bits in Control Register 0 mean?

  The Control Register is used to control the device during and after a configuration. [31:30] Core CLK SEL Control bits to set the core clock frequency respect the internal oscillator frequency. 00 Fosc/2 01 Fosc/4 10 Fosc/5 11 Fosc/6 29 WKUP TRAN ...

• 7014 - Radiant Programmer: Does Radiant Programmer supports XCF file creation and automate programming via Linux OS?

  We currently do not have TCL commands that support creating *.xcf file from scratch that will then be used by Radiant programmer. XCF creation can only be done through Programmer GUI. You could use the PGRCMD command to run the programmer which also ...

• 1060 - How can I avoid the Lattice Radiant/Diamond to implement a 3-stage shift register as RAM-based shift register?

  Description: Lattice Radiant / Diamond software tools will implement the following verilog code as RAM-based shift register instead of keeping the shift components as register. reg [6:0] shft_reg1, shft_reg2, shft_reg3; always @(posedge pclk) begin ...