6235 - Lattice Radiant 3.1.0 : Does SEI editor tool supports CertusPro-NX?

• Related Articles

• 7262 - Radiant and Diamond: HDL pin constraints not seen in Spreadsheet View/Device Constraint Editor

  Description: In Lattice Radiant and Diamond, while using the Spreadsheet View/Device Constraint Editor, it is possible to not see the HDL pin constraints reflected in GUI. Solution: This may be because the pins mentioned in the lines of code have ...

• 6536 - Lattice Radiant: How to resolve the issue in generating output bitstream on Radiant's Deployment Tool?

  Description: The user encounters an error on the Deployment tool when trying to convert their generated bitstream from Radiant. Solution: The issue on the generation of output bitstream is due to the encrypted bit file generated by the Radiant's ...

• 7788 - What are the recommendations for performing Fast Corner Timing Analysis on Certus-NX, CertusPro-NX, MachXO5-NX, and CrossLink-NX FPGAs

  The default settings for Timing Analysis of the Nexus platform in Radiant 2025.2 were updated to use VccMAX for fast corner thold timing analysis. Why VccMAX? Using VccMAX for fast-corner thold analysis provides a more accurate representation of ...

• 7243 - Lattice Radiant: Why do users cannot select the CFG2 address for Dual-boot implementation in MachXO5-NX using Deployment Tool versions 2023.1, 2023.1SP1 and 2023.2?

  Description: The users will not be able to select CFG2 as the starting address of the Golden Image in Deployment tool, The user may encounter a GUI Issue as shown. Solution: This is a known issue and the versions affected are shown below. Notes: 1.) ...

• 6196 - Lattice Radiant: How do I Write values to ROM after implementation using ECO Editor

  In order to use the ECO editor tcl command, you must get the mem_id value from the ECO GUI. The tcl command was meant to record/repeat the operation of the GUI. There is no other way than to use the GUI first to check the id values. Here is the ...