Lattice Diamond Programmer: What Software can be used to program the old and obsolete ispCLOCK device?

• Related Articles

• ECP5 / Diamond 3.14: Why does my design get a Map device oversize error related to PLL for LFE5U-12F in with Diamond 3.14, but completes map successfully in earlier releases of Diamond software?

  In Diamond version 3.14, there is a bug where it incorrectly limits the number of PLLs in the device to 0 for LFE5U-12F. Example error message: ERROR - (device oversize error). The number of PLL components needed (1) exceeds the number available. ...

• 5727 - Programmer: Does the customer-made FT2232H-based programmer supported by the Lattice Diamond Programmer software?

  Lattice is using FTDI chip or FT2232H, therefore technically, the Lattice Diamond Programmer should recognize the available customer-made FT2232H based-hardware. By using Lattice Diamond Programmer Software, you can read and program the device the ...

• 520 - Lattice Power Manager: What is the recommended Programmer to be used for Power Manager II devices?

  Previously, ispVM EMBEDDED (ispVME) was recommended used for Power Manager II devices just as it is with Lattice FPGA's and PLD's. However, This tool is obsolete and is no longer recommended to be used by the customer. Instead, customer can use ...

• 1159 - ispLEVER: Can ispVM System program ispClock or ispPAC-POWR products?

  Yes, ispVM System can be used to program ispClock or ispPAC-POWR devices. User will need to use Pac-Designer to create a JEDEC or Serial Vector Format (.SVF) file to program these devices with ispVM System. The JEDEC file can be created from the ...

• Lattice Diamond and Radiant Programmer: Does Lattice Programmer software and driver support FT4232HQ?

  Both Lattice Diamond and Radiant Programmer are not support FT4232HQ.