Lattice Diamond Programmer: WARNING in Linux OS - Drivers were not detected. Install the Lattice VM Drivers to access the JTAG Chain.<br>

• Related Articles

• Lattice Diamond Programmer: Do JTAG Full VME embedded source files are supporting JTAG Daisy Chain Programming?

  The answer is yes, JTAG Full VME embedded source files are supporting the JTAG Daisy Chain Programming. The chain of devices setup should be done in the Lattice Diamond Programmer file (.xcf) by adding target device/s.

• 1226 - Radiant Programmer: What programmer detected Lattice device as "JTAG-NOP"?

  JTAP-NOP indicates that a device was detected, but its JTAG IDCODE is not available in software device database. There are a few reasons this may occur: 1. The device is a newer Lattice device and is not yet supported by the software tool version ...

• Diamond 3.10 and earlier: How to install Diamond Programmer Standalone version?

  Description: Diamond Programmer comes with the base installation of the Diamond software itself. The standalone version can be used with encryption pack that should be installed after the base of Diamond software. The step-by-step procedure is ...

• Diamond: How to install Diamond Encryption Pack in Linux OS?

  Use below Linux command: sudo rpm --nodeps -ivh <diamond encryption pack> The reason for using nodeps is because the rpm installation checks too strictly for the dependencies. In most cases, Diamond flow works properly with this installation ...

• Diamond 3.12: Why is it that Programmer_Encryption_Security is unable to install?

  Description: The Diamond Programmer version 3.12 installation is corrupt or not installed. Re-install Diamond Programmer 3.12 and try again. Contact Lattice Semiconductor if the problem persists. Solution: Try to install the base SW first then the ...