Lattice Diamond LSE: When trying to instantiate the gddr_7:1 ip core, why do I get a Multiple Driver Error?

• Related Articles

• ECP5 / Diamond 3.14: Why does my design get a Map device oversize error related to PLL for LFE5U-12F in with Diamond 3.14, but completes map successfully in earlier releases of Diamond software?

  In Diamond version 3.14, there is a bug where it incorrectly limits the number of PLLs in the device to 0 for LFE5U-12F. Example error message: ERROR - (device oversize error). The number of PLL components needed (1) exceeds the number available. ...

• [ECP5] Lattice Diamond: Issue encountered during IP generation using VHDL. ERROR - Error Trying to create component

  To workaround this issue, user need to change the synthesis tool from Lattice LSE to Synplify Pro. Steps in changing the synthesis tool: 1.Go to Project. 2. Select Active Implementation. 3. Choose Select Synthesis tool. 4. At Synthesis tool select ...

• Lattice Diamond/DCSC Primtive IP: 2019990 ERROR - Port SEL does not exist. 

  Description: When user used the DCSC Verilog instantiation code from TN02200 and run the design flow compilation, user may observed error in Synthesis run as below. 2019990 ERROR - Port SEL does not exist Solution: To workaround this error message, ...

• Lattice Diamond: Why does my design with Lattice Sentry i2c filter core failed compilation with "Synthesis exit by 9" and "Done: error code 9" error message?

  Description: Users utilize i2c filter encounter Synthesis Exit by 9 when synthesizing their design on Diamond Solution: This is due to wrong FPGA tool selection on the IP parameter. Make sure you choose the correct software tool in the IP core ...

• 2781 - Why do I get the message "ERROR - map: IO buffer em_ddr_data_c_0 drives IO buffer em_ddr_data_pad_0 directly, but this is not possible" on most DDR3 interface signals after instantiation of a Lattice DDR3 IP core?

  This FAQ is applicable to all Lattice DDR memory controller IP cores (DDR1/DDR2/DDR3/DDR3-PHY/LPDDR). When a DDR memory interface signal uses a dedicated DDR I/O function, the DDR memory controller or PHY IP core netlist file (.ngo) includes an I/O ...