Lattice Diamond: Is there a command to generate a .xcf project for scripted or automated programming?

• Related Articles

• Radiant Programmer: Does Radiant Programmer supports XCF file creation and automate programming via Linux OS?

  We currently do not have TCL commands that support creating *.xcf file from scratch that will then be used by Radiant programmer. XCF creation can only be done through Programmer GUI. You could use the PGRCMD command to run the programmer which also ...

• Lattice Diamond: How to save Diamond Project File (.ldf) without exiting Diamond Software?

  You can use "prj_project save" command in Diamond TCL console. This will let you save the Diamond Project file without exiting the Diamond Software.

• 3175 - Lattice Diamond: What is the maximum allowable project path length in Lattice Diamond to prevent Synthesis Failure?

  The maximum project length allowed in Lattice Diamond is same as the maximum allowable path length in Windows operating system which is of 260 characters. Below are the steps to calculate the project path length in diamond. Maximum allowable path ...

• Lattice Diamond Programmer: Do JTAG Full VME embedded source files are supporting JTAG Daisy Chain Programming?

  The answer is yes, JTAG Full VME embedded source files are supporting the JTAG Daisy Chain Programming. The chain of devices setup should be done in the Lattice Diamond Programmer file (.xcf) by adding target device/s.

• 2290 - MachXO: How can I generate VME with Turbo mode in command line ?<br>

  Description: In Lattice ispVM System, you can generate this VME file in the following steps: Create a device list Select Turbo in Project Settings Dialog Box Save the configuration file XCF file Open a Command Prompt Window, change the current ...