Lattice Diamond: How do i allow the tool to analyze the CDC from my design and view paths on Trace reports?

• Related Articles

• 692 - Lattice Diamond:  Does the Lattice timing analysis tool only analyze 4096 timing paths at maximum?

  The timing analysis tool does analyze all timing paths in your design. For timing closure, the analyzer will address all failing timing paths even if they exceed 4096 paths. It is for MAP and Place & Route TRACE reporting purpose only that up to 4096 ...

• 940 - Diamond: Timing: Why are there two trace reports in the Lattice software?

  Diamond: Timing: There are two trace reports (a Map trace report and a Place-and-Route (PAR) trace report) that serve two different purposes. The Map Trace report has estimated routing. It should be used to verify the paths you expect are being ...

• 1800 - Diamond / Spreadsheet View: How does the user determine Simultaneous Switching Noise (SSN) from within Lattice Diamond tools?

  An estimate of SSN can be determined by running the Simultaneous Switching Output (SSO) Analysis tool in the Lattice Diamond Spreadsheet View. Information about SSO Analysis can be found in the Lattice Diamond online help by searching for SSO ...

• Diamond: Is there a section or a tool where user can find the metastable CDC paths and if they are properly handled or not with FIFO or synchronizer FFs?<br><br>

  In the timing report, there is a Clock Domains Analysis (CDC) section. It doesn't report if the CDC is handled properly through synchronizers or FIFOs. This should be the designer's responsibility, as we currently do not have a DRC that checks for ...

• ECP5 / Diamond 3.14: Why does my design get a Map device oversize error related to PLL for LFE5U-12F in with Diamond 3.14, but completes map successfully in earlier releases of Diamond software?

  In Diamond version 3.14, there is a bug where it incorrectly limits the number of PLLs in the device to 0 for LFE5U-12F. Example error message: ERROR - (device oversize error). The number of PLL components needed (1) exceeds the number available. ...