Lattice Diamond: Does the MAXDELAY preference/constraint, and its option MIN, affect PAR? Or is it only used to check against TRACE timing?

• Related Articles

• 212 - Diamond: Why do users have preference items in the trace report with 0 timing score?

  There are several reasons why users will see this happen: The timing constraint specified is covered by another timing constraint in the preference file. This is most often seen when the design has two related clocks. Trace will provide timing ...

• Lattice Diamond: Why are there no paths analyzed for MAXDELAY constraint. How to use MAXDELAY constraints?

  The MAXDELAY constraint used in the design might not be connected, or they are on a different clock. Diamond STA won't analysis on different clock domains unless they are related by clkskewdiff For Example, if two cells are in different clock ...

• 940 - Diamond: Timing: Why are there two trace reports in the Lattice software?

  Diamond: Timing: There are two trace reports (a Map trace report and a Place-and-Route (PAR) trace report) that serve two different purposes. The Map Trace report has estimated routing. It should be used to verify the paths you expect are being ...

• 4072 - Diamond 3.3 / MachXO2: How can a user constraint Place & Route (PAR) for the MachXO2 built in oscillator to cover the 5% frequency tolerance variation?

  Description: In Lattice Diamond 3.3 and later, PAR will accept a frequency constraint up to 5.5% above the nominal frequency setting to cover the timing variation in the oscillator over PVT. This can be done by adding a constraint in the Lattice ...

• 129 - Lattice Diamond: How can I single out a specific path or transfer in the timing analysis TRACE report?

  TRACE lists the paths per timing preference starting from the worst case path going down. Let's say you want to look at a path that maybe the 1001st worst case path in the design. You do not want to list 1001 paths in the trace report. How can this ...