iCEcube2: Why does my IceCube2 Fails to Launch - White screen, not showing on display?

• Related Articles

• Diamond: Why are the icons too small when using Lattice Diamond in 4k (3840 x 2160 pixel) screen resolution

  The problem of Diamond GUI with 4k resolution has to do with its old libraries since Diamond was developed a long time ago. Using 4k screen resolution can cause the software to induce some graphical glitches like small icons or cropped interface. As ...

• 1037 - LatticeMico32: Why does my LatticeMico32 debug session fail to launch?

  Description: A common problem when trying to debug a LatticeMico32 C/C++ project is an error message that reads: "Check that the target FPGA contains an LM32 CPU with DEBUG_ENABLED equal to TRUE and that the FPGA has configured correctly." This error ...

• Radiant Modelsim: How to launch Modelsim from the terminal?

  To launch the modelsim from terminal, use below command: $ <radiant install path>/lscc/radiant/3.1/modeltech/linuxloem/vsim& Example: $ /home/ubuntu/lscc/radiant/3.1/modeltech/linuxloem/vsim&

• Why there are designs passing on MAP showing a good SLICE utilization percentage but failing PAR showing unplaced SLICEs due to 100% SLICE utilization percentage?

  To give a background on this, in a single SLICE, there can be two possible registers/FFs. Map does the SLICE utilization calculation solely based on the number of registers/FF per SLICE. Architecturally, there are 2 FFs/registers and 2 LUTs per ...

• Radiant: Why PAR fails for some PCLK input ports for the Aligned DDR interface?

  Aligned interfaces based on the FPGA-TN-02286: MachXO5-NX HighSpeed IO Interface technote should have DLLDELs connected to their CLKIN ports. Based on FPGA-DS-02102: MachXO5-NX Family datasheet, only even PCLKs are connected to DLLDELs. PCLK<Bank ...