6949 - How can users have access to old versions of the Lattice SW?

• Related Articles

• 7243 - Lattice Radiant: Why do users cannot select the CFG2 address for Dual-boot implementation in MachXO5-NX using Deployment Tool versions 2023.1, 2023.1SP1 and 2023.2?

  Description: The users will not be able to select CFG2 as the starting address of the Golden Image in Deployment tool, The user may encounter a GUI Issue as shown. Solution: This is a known issue and the versions affected are shown below. Notes: 1.) ...

• 1030 - ispLEVER Classic / Installation: How to run ispLEVER tools on Windows 7 32-bit versions?

  Solution: ispLEVER is not supported to run on Windows 7 operating system. Based on our initial tests, we were able to run ispLEVER in the command line mode without any or minimal issues. ispLEVER is not fully compatible with Windows 7 when running in ...

• 1964 - Diamond: How can users disable irrelevant clock domain crossings during the device implementation?

  Timing paths that contain clock domain crossings are paths between two registers that are clocked with two clocks. After performing timing analysis using Place and Route TRACE, such timing paths usually have the following source and destination ...

• 5908 - Lattice Diamond: Does Lattice recommend porting/converting of IP from different device with different IP version?

  Lattice does not recommend users to do porting/conversion of IP from/to different device in different IP versions. Example: FFT Compiler v2.8 does not support ECP5 device. FFT Compiler v2.9 supports ECP5 device. If user used FFT Compiler v2.8 and ...

• 5330 - Diamond Programmer: Does Diamond Programmer software have versions that support 32-bit Windows?

  You can find the 32-bit versions of Diamond Programmer in our software archives located at http://www.latticesemi.com/en/Support/SoftwareArchive.aspx