6883 - Diamond 3.4 and below: Error: "The procedure entry point "FLSAlloc" was not found in the DLL "KERNEL32.dll""

• Related Articles

• 7733 - ECP5 / Diamond 3.14: Why does my design get a Map device oversize error related to PLL for LFE5U-12F in with Diamond 3.14, but completes map successfully in earlier releases of Diamond software?

  In Diamond version 3.14, there is a bug where it incorrectly limits the number of PLLs in the device to 0 for LFE5U-12F. Example error message: ERROR - (device oversize error). The number of PLL components needed (1) exceeds the number available. ...

• 7308 - Diamond: Error "Missing MSVCP110.dll"

  Description: When running Lattice Diamond and encountering the error: "Missing MSVCP110.dll". This issue is commonly caused by Microsoft VC Redistributable not being properly installed or corrupted on your PC/Laptop. Solution: We highly suggest ...

• 7765 - QuestaSim: simulation takes long and error out "failed to start simulation kernel"

  Description: Users try to run any simulation with QuestaSim. It will take a long time to run, possibly hours. It eventually errors out "failed to start simulation kernel". Solution: Please try the following steps. If the problem persists, you may ...

• 6812 - OEM Modelsim: How do i resolve MSVCR120.dll error when executing Modelsim tool?

  Description: When opening modelsim users may encounter an error relating to a .dll file. Solution: To resolve this issue, Install VC2013 redistributable vcredist_x86 to your system as the modelsim relies on its libraries.

• 7288 - Diamond: Error "Data Transfer Error Information"?

  Description: When installing Diamond on a Windows machine, the error below might occur: "Data Transfer Error Information" Solution: Please refer to any of the below solutions to resolve the issue: 1. The issue seems to be from a corrupted installer. ...