Can Avant Global Set/Reset Resources be analyzed through the Static Timing Analysis Tool on Radiant?

• Related Articles

• 3017 - Why cannot I pack two registers with the same clock/clock enable/reset signals into one slice after MAP?

  Based on Lattice FPGA architecture, two flip flops in a slice share the same clock/clock enable/reset signals. So the two registers can be packed into one slice if their control signals are same. But sometimes if the reset and/or clock enable signals ...

• 6973 - [Avant-E] Radiant 2022.1: How to fix DQS/DQ grouping issue?

  Solution: We have to implement the controller as x32 data bus and in that case the pinout of AVANT-E eval board rev C can be used. Radiant works with that complete pinout so both channels must be driven using the x32 configuration.

• 578 - How do I use the ispMach4000 global clocks?

  Global clock signals are low skew signals which save macrocells and routing resources when taken advantage of. Use your clocks like normal in your design. Note these cannot be gated clocks. Next using the Constraint Editor connect them to the global ...

• 655 - How is the Global Set Reset (GSR) used in a design? Do I need to use the GSR symbol or component in my design to use the GSRN pin for the MachXO device?

  For the Lattice MachXO device, all the registers in the device will be reset upon power-up of the device, provided the power-up sequence is clean. This will happen without any additional effort on the part of the user. The software will evaluate the ...

• 5276 - CrossLink: What is the purpose of reset_n_i signal? Is there any input timing requirement for it?

  In CrossLink IPs, reset_n_i is the asynchronous reset which is used in the design to reset the state machine, flipflops, logics to the initial state. There is no specific timing requirement because it is asynchronous reset so you can reset at any ...