804 - Power Manager II: How to read the value of NODES in the PAC-POWR1220AT8 via I2C?

• Related Articles

• 442 - Can I read the value of NODES in the POWR1220AT8 via I2C?

  The NODES in PAC-Designer for the POWR1220AT8 do not have any I2C registers associated with them and therefore you cannot directly read value of NODES via the I2C interface. If the NODE is routed to an actual output (HVOUT1-4 or OUT5-20) then you can ...

• 443 - Can I read the value of NODES in the POWR1014/A via I2C?

  The NODES in PAC-Designer for the POWR1014/A do not have any I2C registers associated with them and therefore cannot be read directly via the I2C interface. If the NODE is routed to an actual output (HVOUT1-2 or OUT3-14) then the value of the NODE ...

• 413 - How do I implement Power-Off Detection in a Power Manager II device ?

  The Power Off Detection is used to sense when a supply (or set of supplies) is fully discharged before re-cycling the power-on or re-start sequence. Many devices require the supplies to be fully off before applying power and a Power Off Detection ...

• 2521 - Power ManagerII: Where can I find the process technology information for the Power Manager II products?

  Solution:Lattice publishes a Product Family Qualification Summary for the Power Manager II products, found on our website at this link: Power Manager Qualification Summary. This document provides details on the qualification process and results for ...

• 433 - How can I sense current with a Power Manager II?

  The Power Manager II devices can not measure current directly. However, the Application Note AN6049 shows several circuits that can be used with a Power Manager II device to measure current. The circuits shown convert the current into a voltage that ...