7505 - PAC Designer: Error: Kernel Mode driver is not loaded in a memory

Description: Since PAC-Designer is a legacy software, the Design Utility included in it has drivers that are only compatible with Windows XP and when invoked on other Windows Operating Systems, the error below will occur: Error: Kernel Mode driver is not loaded in a memory Solution: A recommended workaround is to use a Windows XP virtual machine inside Windows 7/10 to run the utility out of PAC-Designer. This can be accomplished by installing Windows XP mode from Microsoft or another virtual machine software that can access the USB ports of the PC. Make sure to restart the system after installing the PAC designer software with admin rights. Note that there will be no further updates on PAC-Designer.

Related Articles
1853 - PAC Designer: What does the error message “The application has failed to start because the application configuration is incorrect. Reinstalling the application may fix this problem” mean when launching PAC Designer?
This error message typically occurs when a user does not have Microsoft's .NET framework set up correctly for their machine. The necessary components are also provided with PAC-Designer, and can be manually installed by running the file ...
651 - PAC-Designer: Why does my LogiBuilder design fail to compile?  <strong>PAC-Designer</strong> fails with: F38009 Invalid Node assignment for signal 'pin assignment'.
PAC-Designer: PAC-Designer will issue this error message if an output is set to be controlled by I2C and that same output is used in a Boolean equation. The fitter drops the output macrocell from the resource list as I2C is controlling the pin. ...
PAC-Designer: Which version of PAC-Designer supports ispClock 5500?
PAC-Designer version 4.8 support ispClock 5520 and 5510. Here is the download link of the installer for Windows: https://www.latticesemi.com/view_document?document_id=21833 Please note that ispClock 5500 is already a discontinued product. ...
2310 - PAC-Designer:  Why does my POWR1014A design fail to compile but not give an error message?
If your Power Manager II design fails to compile and gives no error message it could be due to the use of periods or spaces in the project file name or the path name. Usually the failure message is produced immediately after starting the compile ...
2848 - PAC Designer Trim Configuration: if the Profile0 mode is changed from Closed Loop Trim (CLT) to I2C, does the calculated value of resistors change?
In the Trim Configuration of PAC-Designer software for the Profile0 Mode, the calculated value of resistors remains the same regardless of whether I2C or CLT is used. To have the correct resistor network between POWR1220AT8 and the DC-DC converter, ...

7505 - PAC Designer: Error: Kernel Mode driver is not loaded in a memory

7505 - PAC Designer: Error: Kernel Mode driver is not loaded in a memory

Related Articles

1853 - PAC Designer: What does the error message “The application has failed to start because the application configuration is incorrect. Reinstalling the application may fix this problem” mean when launching PAC Designer?

651 - PAC-Designer: Why does my LogiBuilder design fail to compile?&nbsp;&nbsp;<strong>PAC-Designer</strong> fails with: F38009 Invalid Node assignment for signal 'pin assignment'.

PAC-Designer: Which version of PAC-Designer supports ispClock 5500?

2310 - PAC-Designer:&nbsp; Why does my POWR1014A design fail to compile but not give an error message?

2848 - PAC Designer Trim Configuration: if the Profile0 mode is changed from Closed Loop Trim (CLT) to I2C, does the calculated value of resistors change?

651 - PAC-Designer: Why does my LogiBuilder design fail to compile? <strong>PAC-Designer</strong> fails with: F38009 Invalid Node assignment for signal 'pin assignment'.

2310 - PAC-Designer: Why does my POWR1014A design fail to compile but not give an error message?