7496 - Radiant: ERROR <1081326> - Bitstream cannot be generated, either because this device does not support IP Evaluation Mode or the Bitstream Strategy Setting for IP Evaluation Mode is set to False

• Related Articles

• ECP5 / Diamond 3.14: Why does my design get a Map device oversize error related to PLL for LFE5U-12F in with Diamond 3.14, but completes map successfully in earlier releases of Diamond software?

  In Diamond version 3.14, there is a bug where it incorrectly limits the number of PLLs in the device to 0 for LFE5U-12F. Example error message: ERROR - (device oversize error). The number of PLL components needed (1) exceeds the number available. ...

• Lattice Radiant: Why does the constraint coverage did not improve after using set_false_path constraint?

  By Default, set_false_paths does not improve constraint coverage, however For Radiant 2023.1 or later, the user can use the Timing Command Line Option "-false_covers" to add in the false paths to the timing coverage. This can be applied on the ...

• Diamond / Synplify Pro: Why is the Frequency for Synplify Pro Strategy Setting is set to 1 MHz when using the Area preset strategy?

  When selecting Area preset strategy, the Frequency setting on the Synplify Pro will change to 1 MHz. If the user changes Frequency setting this to a mid or higher value, the optimization will try to meet that higher frequency and therefore the area ...

• All Nexus / Radiant: Why can't users see reset signals on the timing analysis reports even without setting the set_false_path constraints?

  Resets are not timed or cannot be checked on the timing analysis reports if they are using Global/Set Reset (GSR) component. GSR will be used if the following are set: 1. GSR is instantiated on the RTL and set to the reset signal. 2. GSR-related ...

• 6603 - Radiant: How to perform IP re-generation using ipgen?

  First, run "ipgen.exe -h" from the tcl console to view all the command options as shown below. usage: ipgen.exe [-h] [-o OUTPUT_DIR] [-proj_dir PROJ_DIR] -ip IP_MODULE_DIR [-cfg IP_CONFIG_FILE] [-skip_uniquify SKIP_UNIQUIFY_HDL] [-cfg_value ...