7461 - ispLever Classic 2.1: Why is the "PULL" option of ispLever Classic not editable for designs using ispMACH 4000V/B/C/Z device?

• Related Articles

• 1030 - ispLEVER Classic / Installation: How to run ispLEVER tools on Windows 7 32-bit versions?

  Solution: ispLEVER is not supported to run on Windows 7 operating system. Based on our initial tests, we were able to run ispLEVER in the command line mode without any or minimal issues. ispLEVER is not fully compatible with Windows 7 when running in ...

• 712 - ispLEVER Classic: What are the things that can prevent ispLEVER Starter from installing correctly?

  Solution: Due to the differences in hardware and software, there are differing reasons why the Lattice ispLEVER Starter software may have problems installing. Below is a list of things to check and try when diagnosing an ispLEVER installation ...

• 757 - ispLEVER Classic: What does the "Information in file ispsys.ini does not match the system" error mean?

  Solution: The message that you are getting indicates that there is a mismatch between the registry settings and the ispLEVER "*.ini" file. e.g."lsc_1_3.ini" file (for ispLEVER Classic 1.3). The "ispsys.ini" file points to the "*.ini" file (e.g. ...

• 3590 - ispLEVER Classic v1.7: Where do I find the IPexpress in the software? <br>

  Solution: One can generate the IP using Module-IP Manager that comes along with the ispLEVER Classic 1.7 Installation. The Module-IP Manager can be invoked as follows. Select Windows > All Programs > Lattice ispLEVER Classic 1.7 > Module- IP Manager

• 380 - ispLEVER Classic/Diamond Reveal Analyzer: using a JTAG chain with multiple devices

  Reveal Logic Analyzer can be used for On-Chip Debug even if the targeted device is a JTAG chain with multiple devices. Use ispVM to define the JTAG chain and the position of the targeted device in the chain. Then, save the chain (.xcf) file and ...