7424 - [All Nexus] Lattice Radiant Programmer: Is there a default readout for the encryption key of Nexus Devices?

• Related Articles

• Radiant Programmer: What is Erase, Program, Verify Quad 1 operation used for?

  Description: Erase, Program, Verify Quad 1 enables that QE bit to '1'. In general, there are two (2) requirements/steps to enable booting from external SPI Flash through x4 (QUAD Mode) Step 1 - Convert the bitstream file into hex (Quad I/O read mode) ...

• 529 - LatticeECP3: Can the LatticeECP3 still be programmed after setting the encryption key?

  No. Before the introduction of encryption, all bit streams are not protected in terms of security. Anyone can copy the design simply by reading the bit stream out of the boot PROM. With LatticeECP3 bit stream encryption, there is another level of ...

• 1644 - LatticeECP3: Is there a recommended way of choosing AES (Advanced Encryption Standard) encryption key?<br>

  We implemented the AES (Advanced Encryption Standard) block based on its standard. Any analysis of the strengths and weaknesses of AES is performed by the standard's committee. Studies for the strength of AES encryption key have been documented by ...

• 7409 - [MachXO3] Lattice Diamond Programmer: Is feature row updated when programming password key?

  Description: Lattice Diamond programmer programs the PWD enable bit to "1" on the feature row after shifting the password. This enables the security feature right after shifting the password.

• 6186 - Lattice Radiant Programmer: How user can Flash FPGA binary file (.rbt) and Propel SDK (RISC-V) binary file to Lattice FPGA?

  To flash FPGA binary file (.rbt) user can use the provided C source code in the Lattice software installation directory for embedded programming. C source code for Radiant: <install_path>\programmer\embedded_source Example: C:\lscc\radiant\<Radiant ...