7409 - [MachXO3] Lattice Diamond Programmer: Is feature row updated when programming password key?
Description:
Lattice Diamond programmer programs the PWD enable bit to "1" on the feature row after shifting the password. This enables the security feature right after shifting the password.
Related Articles
5736 - MachX03: What is the difference between "Security Program Password Key" and "Security Program Password Key With Lock" in terms of Feature Row mapping?
The difference between "Security Program Password Key" and "Security Program Password Key With Lock" is that Security Program Password Key With Lock enables Secure PWD which is a bit that locks the feature row. For JTAG, the flow is: Send in 8 bits ...
5628 - MachXO3L: What is the difference between "Security Program Password Key" and "Security Program Password Key with Lock" operations?
The 'Security Program Password Key' operation secures the sectors SRAM, CFG, and Feature Row only, the UFM is not protected and can be read anytime. Meanwhile, the 'Security Program Password Key' operation secures the sectors SRAM, CFG and Feature ...
7118 - MachXO3D: Why does MachXO3D device flash programming operation failed with "ERROR - Failed in Function FLASH_ENABLE" when Password Protection was enabled?
Description: After user enabled Password Protection feature in Diamond Programmer and program the passkey into MachXO3D device, user may experienced Flash Programming Mode operation failed with the following error message: ERROR - Failed in Function ...
5248 - Crosslink: How to program the CrossLink through I2C with Lattice Diamond Programmer and Lattice HW-USBN-2B download cable or MCU-based I2C programming using I2CEMBEDDED?
The CrossLink device is programmable using SPI or I2C. Thus, the programming is supported through: 1. SPI/I2C-based embedded programming (SSPIEMBEDDED or I2CEMBEDDED) using an Embedded MCU, or 2. SPI/I2C operations through Lattice Diamond Programmer ...
5494 - I2C: What is difference between option "I2C Erase,Program,Verify,Feature" and option "I2C Program Feature Row"?
Description: The I2C Erase, Program, Verify option requires that the Feature Row be programmed prior to the execution of the "I2C Erase, Program, Verify" operation. This operation checks for the Feature Row match between the device and the JED file, ...