7150 - IO for Nexus FPGAs: How to set the IO standard to "subLVDS" in GPIO option that is not included in DDR_Generic IP generation?

• Related Articles

• 6817 - IO for ECP5/ECP5-5G

  ECP5 can utilize any GPIO as reset on their design, In order to utilize a dedicated routing for the reset, users may use the GSR (Global Set/Reset IO) resource. The primitive can be utilized either through inference or design instantiation. If it is ...

• 7197 - All Nexus: What is the default drive strength for I/O pins?

  Description: This article lists the default drive strength for different IO_TYPE for Nexus products. Solution: For Nexus products, these are the default drive strength set in Radiant SW according to the IO_TYPE, and they are applicable for both Wide ...

• 5322 - MachXO3: Can MachXO3 support HSTL18 IO standard?

  HSTL18 standard is NOT supported in MachXO3. HSTL18 is only supported in MachXO2

• 879 - LatticeXP2: How can I drive mini-LVDS output on LatticeXP2 if mini-LVDS IO standard is not available? <br>

  If user's design is using 50 ohm PCB trace and cable impedances, user can set the LatticeXP2 IO output type to LVDS and this will produce 400mv peak signal swing at the receiver's 100 ohm termination with proper common mode output voltage. The ...

• 241 - IO Simulation: How to simulate&nbsp;open drain IO/s?

  An open drain IO drives output high as a 'Z' and drives low as a '0'. These IOs are often used when multiple devices are connected to a bus. On devices that do not have an open drain option, you can simulate an open drain circuit using an OE on the ...