7078 - CertusPro-NX/PCI Express: Why would the host PC crash when running the PCIe DMA Throughput Demo of CertusPro-NX?

• Related Articles

• 7002 - PCIe for Nexus FPGAs: Where to download the PCIe Demo driver source code for Linux and Windows?

  Description: The PCIe demo driver source code for Linux and Windows can be downloaded from below link: Scroll down the page and choose the appropriate PCIe Demo designs from the list. ...

• 6447 - CertusPro-NX PCIe: Does both Quad 0 and Quad 1 support hard IP block of PCIe link layer?

  CertusPro-NX only supports the hard IP block PCIe link layer on Quad 0. For more information, refer to second paragraph of section '11.1. PCI Express Mode' on FPGA-TN-02245.

• 2069 - LatticeECP3: What is the usage of WB_CTI_I signal in the Lattice PCI Express Scatter Gather DMA Demo design?

  WB_CTI_I is a Wishbone user defined signal for tagging the cycle as a single or burst access. In the Lattice PCI Express Scatter Gather DMA Demo design, the signal is driven by the SGDMA IP (Wishbone master). It is sourced by the EBR module (Wishbone ...

• 6236 - PCIe for Nexus FPGAs: What is the total amount of PCIe interfaces in CertusPro-NX-100 with different lanes?

  The PCI Express Link Layer Quad for all CertusPro-NX devices has four PIPE interfaces that can be used in different number of links. This can provide the maximum flexibility, depending on the bandwidth of the application requirements. The PCIe link ...

• 1061 - Lattice All FPGAs: Which device is the minimal device needed to support PCI Express x1 and x4 core?

  The PCI Express x1 and x4 IP Core is supported by both SC and ECP2 device families. The minimal ECP2M device needed to support the core is LFE2M-20E-6F484C, and the minimal SC device needed is LFSC3GA15E-6F900C. Newer Lattice FPGA families that ...