7041 - Diamond 3.9 and All MachXO: Why here is no simulation model for SEDFA/SEDFB Primitive with its support devices?

7041 - Diamond 3.9 and All MachXO: Why here is no simulation model for SEDFA/SEDFB Primitive with its support devices?

Description:

After installing Diamond, I find under "xxxx\cae_library\simulation", there not have a simulation model for XO3L SEDFA/SEDFB Primitive.

Look into this, I find XO2 device also not have a simulation model for SEDFA/SEDFB Primitive.

Solution:

The SEDFA & SEDFB models are in the black boxes after compilation, which should be inside C:\lscc\diamond\Diamond_version\cae_library\simulation\blackbox\machxo3l_black_boxes. However, the user will not be able to see it.

Related Articles
6527 - iCE40 LP/HX: Does iCE40 LP384 support SB_WARMBOOT device configuration primitive?
SB_WARMBOOT is supported for all iCE40 Devices except for the iCE40-LP384.
2301 - What are the differences between the specific SPI Flash devices listed in the Lattice programming  software tool?
Solution: Users wishing to program a SPI Flash device with either ispVM System or Diamond Programmer are required to select a specific make and model of the targeted SPI flash device. The software utility separates the selections by manufacturer and ...
534 - MachXO: Why can't I scan or program the MachXO device on the MachXO Mini board after I programmed my pattern into the device?
The MachXO JTAG pins on the MACHXO Mini board share the same traces with some generic IOs of the MachXO device (as shown on page 4 and page 2 of the schematic). If the new design patterns have signals driving out of these pins, they could potentially ...
1978 - LegacyDevices: What types of JTAG multi chain designs does the Lattice ispVM System software support? </p>
Solution: The Lattice ispVM System software supports multi-chain BSCAN2 designs as described in the application notes AN8081 and AN8083 at: For other types of multi-drop JTAG designs, third party tools have been shown to be of help to connect the ...
2264 - Model 300 Programmer: What is the procedure to program a generic JTAG device using SVF Files and Model 300 Programmer?
The Model 300 Programmer can program any generic JTAG device, provided user have the correct SVF file for it. User can program any JTAG device that has a SVF file by selecting the correct adapter footprint and voltage in the Model 300 Programmer main ...