6983 - MachXO3/MachXO2:How to monitor INITN in case the current package do not pin-out initn?

• Related Articles

• 534 - MachXO: Why can't I scan or program the MachXO device on the MachXO Mini board after I programmed my pattern into the device?

  The MachXO JTAG pins on the MACHXO Mini board share the same traces with some generic IOs of the MachXO device (as shown on page 4 and page 2 of the schematic). If the new design patterns have signals driving out of these pins, they could potentially ...

• 142 - What is a possible reason for the INITn pin going low while loading configuration image from SPI flash device?

  One possible reason for a configuration loading error can be the image content loaded into the SPI flash. Some serial SPI Flash devices do not guarantee the data integrity of the first few bytes during a read. To address the issue, the ...

• 5558 - What is the max current that can be sourced from the 5V Out pin on the HW-USBN-2B programming cable?

  The "5V Out" pin is directly connected to the USB's 5V supply. You can determine the maximum current by checking the USB port specifications. This is typically around 500mA on USB 2.0 ports. It could be higher or lower depending on the manufacturer.

• 1681 - MachXO2: What happens if the PROGRAMN pin is toggled before device configuration is completed when in SPI configuration mode?

  The PROGRAMN pin is used by the MachXO2 configuration logic to initiate programming of the device. Generally this pin is held inactive high during configuration. In the MachXO2, SPI configuration will restart when PROGRAMN is toggled during ...

• 1977 - Do I need to purchase "28-pin converter" to program a Lattice Device with my Model 300 Programmer?

  Lattice provides a wide array of adapters for programming Lattice products via a desktop programmer from Lattice or 3rd party vendor. A 28-pin converter (Lattice Part Number "pDS4102N-28P2SAB") is required for use with Lattice socket adapters only if ...