6929 - What is the difference of ICE40LP1K-CM36 vs. -CM36A, and if the design can be shared on the same board?

• Related Articles

• 7748 - Why is there a mismatch between the hardware checklist and the evaluation board circuit design?

  Description: The customer has observed discrepancies between the design recommendations provided in the Hardware Checklist and the actual design implementation on the Lattice Evaluation Board. Reason: Hardware Checklists are developed after ...

• 3292 - MachXO2: From where can I download the Demo Design Files for the MachXO2-7000HE/1200ZE Breakout Board?

  The MachXO2-7000HE/1200ZE Breakout Board Demo Design Project can be downloaded from the Lattice Website from the below link: http://www.latticesemi.com/en/Products/DevelopmentBoardsAndKits/MachXO2BreakoutBoard.aspx On the above page, go to section ...

• 3968 - How to get device specifications relevant for custom board design?

  Lattice provides device specifications that help PCB designers in creating custom board designs. These device specifications are cataloged in the Package Diagrams pdf file. The Package Diagrams document provides information on physical dimensions and ...

• 6503 - MachXO2: Should I power up Vcc or Vccio first in my board design?

  Vcc/Vccio Power up sequence of device will not result in excessive current. It does not make much difference whether Vcc is powered up first or Vccio. There is no best or worst sequence . This is both for HC and ZE devices.

• 3755 - iCE40: Why did the iCEstick board get damaged while loading a bitmap to iCEstick's FLASH memory? How to recover the damaged board?

  While loading a bitmap to iCEstick's flash memory ensure that: - In your design no dedicated General Purpose Input/Output (GPIO) pin has been used as an output pin. If, for example, pin 21 has been assigned for output, please replace it with another ...