6914 - Power Manager II: User is having issue to get simulation work with their own design, which apparently has open '(' and close ')' bracket in their .PAC file name.

• Related Articles

• 2363 - PAC-Designer:&nbsp; Why does user design fail to compile with a Warning 1211: Generate NAF file failed?<br>

  If the user Power Manager II design fails to compile and gives a Warning 1211 in the error message window it may be caused by using spaces or periods in the project file name or path name. AHDL2BLF; ABEL-HDL Processor PAC-Designer 6.30 Copyright(C), ...

• 1490 - PAC-Designer:&nbsp;How do PAC-Designer's project archiving functions work?

  PAC-Designer: It is often necessary to send a PAC-Designer design to a colleague, or save it in a revision database. Some device types, such as the Power Manager product families contain multiple files. To aid in organizing these files, PAC-Designer ...

• 1896 - PAC Designer: How to resolve the issue of unable to view the simulation waveform window in PAC-Designer?

  Make sure that your design is compiled and fitted successfully. Then check your project path / file (.pac) name. The naming convention in PAC-Designer software does not support spaces in its pathname or filename. This is because PAC-Designer is ...

• 2310 - PAC-Designer:&nbsp; Why does my POWR1014A design fail to compile but not give an error message?

  If your Power Manager II design fails to compile and gives no error message it could be due to the use of periods or spaces in the project file name or the path name. Usually the failure message is produced immediately after starting the compile ...

• 1734 - PAC Designer / Power Manager II: How to implement a reset in the code?

  Solution: The reset function can be assigned to an IN Input pin and an equation can be written in the Exceptions or in the Supervisory Logic section. Reset can be accompanied with a Timer and simple or complex equations can be used to activate it. ...