688 - PAC-Designer: How to view the internal DAC settings within the ispPAC-POWR1220AT8?

• Related Articles

• 2574 - PAC Designer: Is it possible to manually assign TRIM DAC output voltages to Power Manager II Devices, rather than using the trim configuration calculator?

  Solution:It is possible to assign manual DAC codes to the different profiles of the Power Manager II TRIM DAC outputs. The menu interface for manual assignment can be found in the Edit->Symbol menu in the top level schematic view of PAC-Designer. The ...

• 2449 - PAC Designer; L-ASC10: During Trim configuration in PAC-Designer, I receive an error when calculating DAC settings for my target profiles. What can cause this?

  Solution:The Trim calculation references settings which can be configured in the Trim Configuration Options menu. In some cases you can fix the errors by increasing the "Maximum Supply Adjustment Range" from the default value of 5%. In other cases, ...

• 466 - PAC-Designer: How to connect the POWR6AT6 Trim-DAC control to an analog-digital converter (ADC)?

  Solution: The control logic for each POWR6AT6 Trim-DAC output is automatically connected to the analog-digital converter (ADC) and the respective Voltage Monitor (VMON) input. This is done such that the voltage applied to VMON1 is converted by the ...

• 1895 - PAC Designer: How to change the I2C Address of the ISPPAC1014A device using the I2C Utility within PAC-Designer?

  Users cannot change the I2C address of the POWR1014A using the I2C utility. This only sets the address that gets used by the utility to communicate to the POWR1014A. The I2C address for the POWR1014A device is specified using the schematic sheet of ...

• 1159 - ispLEVER: Can ispVM System program ispClock or ispPAC-POWR products?

  Yes, ispVM System can be used to program ispClock or ispPAC-POWR devices. User will need to use Pac-Designer to create a JEDEC or Serial Vector Format (.SVF) file to program these devices with ispVM System. The JEDEC file can be created from the ...