671 - What is the minimum reset pulse width needed to reset a POWR605?

• Related Articles

• 6711 - Lattice ECP5: What is the minimum pulse width on DIRECTION, LOADN and MOVE?

  The minimum width check for LOADN/MOVE/DIRECTION signal is 2500 ps. The delay setting is effective only after min time of 810 ps after the falling edge of MOVE signal.

• 406 - Where is the Reset pin for the Power Manager II - POW607 ?

  The POWR607 has a power down feature so that when the device is powered back up (using the IN1 pin) the sequence restarts at power up. If a more traditional reset function is desired, then IN1 (or any other input pin) can be used in the LogiBuilder ...

• 1666 - Power Manager II: Can I use the RESETb pin on a POWR1014 or POWR1220 to reset other parts of my circuit?

  The RESETb pin on an ispPAC-POWR1014 or ispPAC-POWR1220 is bidirectional (open drain with internal pull-up). Its primary function is to be used as an input so that one can reset the device after it has been powered up. The secondary function of this ...

• 5276 - CrossLink: What is the purpose of reset_n_i signal? Is there any input timing requirement for it?

  In CrossLink IPs, reset_n_i is the asynchronous reset which is used in the design to reset the state machine, flipflops, logics to the initial state. There is no specific timing requirement because it is asynchronous reset so you can reset at any ...

• 3878 - iCE40: What is the state of flip-flops during Power On Reset (POR) in iCE40 devices?

  The global reset control signal connects to all Programmable Logic Blocks (PLBs) and Programmable Inputs/Outputs (PIOs) flip-flops on the iCE40 device. The global reset signal is automatically asserted throughout the configuration process, forcing ...