6597 - Crosslink-NX: What is the boot-up time for the Crosslink NX device?

• Related Articles

• 6917 - MachXO5-NX: How to speed up the MachXO5-NX (LFMXO5-25) boot/configuration time through its internal flash?

  See below steps to significantly improve the boot/configuration time from internal flash: 1.) In your source project, generate a bitstream that contains the following: * Set the FLASH_CLK_FREQ = 112.5MHz * Set CONFIG_IOSLEW = FAST

• 3817 - LatticeXP2: Is the download/configuration time from Internal/External SPI Flash different while using Dual Boot Mode in LatticeXP2 device?

  While using Dual Boot Mode, the configuration time (time required for the bitstream to get configured inside the device) from Internal Flash is less. Data transfer is faster because the Internal Flash interface with SRAM is parallel, whereas it is a ...

• 1421 - How do I trigger the Dual Boot function for MACHXO2 device?<br>

  The Dual Boot feature is supported through the Master SPI Mode(MSPI) for MACHXO2 device. During the device configuration at power up or toggling of PROGRAMN pin, any of following situations will trigger a dual boot event. A bitstream Cyclic ...

• 7070 - MachXO5-NX: How to perform Dual-Boot using MachXO5-NX?

  See below for steps on how to perform Dual-Boot in MachXO5-NX Background: The current implementation of Dual-Boot is that the JUMP table is found at Address 0.

• 5192 - CrossLink: What is the boot up sequence time for CrossLink when booting up from NVCM/SPI PROM?

  If booting up from internal NVCM, the sequence of events after power up is provided below (Note: Timing numbers are prorated from full chip simulation.): 1. After the analog POR is triggered at around 800 mv for Vcc and 1.5 V for Vccio, digital delay ...