651 - PAC-Designer: Why does my LogiBuilder design fail to compile?&nbsp;&nbsp;<strong>PAC-Designer</strong> fails with: F38009 Invalid Node assignment for signal 'pin assignment'.

• Related Articles

• 2363 - PAC-Designer:&nbsp; Why does user design fail to compile with a Warning 1211: Generate NAF file failed?<br>

  If the user Power Manager II design fails to compile and gives a Warning 1211 in the error message window it may be caused by using spaces or periods in the project file name or path name. AHDL2BLF; ABEL-HDL Processor PAC-Designer 6.30 Copyright(C), ...

• 2310 - PAC-Designer:&nbsp; Why does my POWR1014A design fail to compile but not give an error message?

  If your Power Manager II design fails to compile and gives no error message it could be due to the use of periods or spaces in the project file name or the path name. Usually the failure message is produced immediately after starting the compile ...

• 2358 - PAC-Designer:&nbsp; An output pin in the PAC-Designer project is now assigned as a node. Why did it change and how can the user change it back to an output?

  The PAC-Designer Logibuilder software should not assign an output as a node, this is an issue in earlier versions of the software. A PAC-Designer project with this assignment is corrupted and cannot be fixed inside PAC-Designer. Recommendation is to ...

• 1930 - PAC Designer: What causes a design to fail to compile with the error f38009 or invalid p38031?

  There are two issues which may cause these errors with a design. The first is that in order to use an Output on the right hand side of a supervisory equation it must also be assigned a value somewhere in the design. It could be assigned in a step of ...

• 1467 - PAC-Designer:&nbsp;How can I set up the simulation time in PAC Designer ?

  PAC-Designer: To simulate a design with Lattice Logic Simulator, the design must first be entered or edited using both the schematic windows and the LogiBuilder Sequence Editor. Next, a stimulus file should be created or edited using the Waveform ...