6434 - MachXO3: What is the configuration phase time in the start-up phase of MachXO2 and MachXO3 Devices?

• Related Articles

• 1705 - What is the start point of “input operation” and the start point of “output operation” after TransFR command in “Leave Alone” I/O State?

  The use of the TransFR command is discussed in more detail in TN1087, Minimizing System Interruption During Configuration Using TransFR Technology. This tech note is available from the Lattice web site at the following web link: ...

• 2125 - What is the device programming time of a Lattice FPGA?

  Solution: The time to program a Lattice FPGA is dependent on several factors including configuration mode, programming speed, and device size. Some configuration modes and methods are faster than others. The complete configuration time inherently ...

• 6917 - MachXO5-NX: How to speed up the MachXO5-NX (LFMXO5-25) boot/configuration time through its internal flash?

  See below steps to significantly improve the boot/configuration time from internal flash: 1.) In your source project, generate a bitstream that contains the following: * Set the FLASH_CLK_FREQ = 112.5MHz * Set CONFIG_IOSLEW = FAST

• 6823 - iCE40 Family: What is the recommended Configuration Mode for NVCM in iCE40 devices?

  Description: It is reported that Fast Boot Mode encounters issue when configuring the device in some cases. Solution: The users should implement a Low or Medium Frequency Boot Mode for iCE40 Devices as this provides a more reliable configuration ...

• 3817 - LatticeXP2: Is the download/configuration time from Internal/External SPI Flash different while using Dual Boot Mode in LatticeXP2 device?

  While using Dual Boot Mode, the configuration time (time required for the bitstream to get configured inside the device) from Internal Flash is less. Data transfer is faster because the Internal Flash interface with SRAM is parallel, whereas it is a ...