6408 - Embedded Programming: Can the whole data file be transmitted with just one start and one stop condition?

• Related Articles

• Radiant Programmer: What is Erase, Program, Verify Quad 1 operation used for?

  Description: Erase, Program, Verify Quad 1 enables that QE bit to '1'. In general, there are two (2) requirements/steps to enable booting from external SPI Flash through x4 (QUAD Mode) Step 1 - Convert the bitstream file into hex (Quad I/O read mode) ...

• 4988 - What are the programming considerations for SSPIEM and I2CEM modification with Aardvark SPI/I2C APIs?

  Aardvark is a SPI/I2C adapter which can be used for programming of Lattice FPGA devices with Slave SPI or Slave I2C. Lattice Diamond provides SSPIEM and I2CEM example source codes which are modified with Aardvark SSPI and I2C API’s respectively. ...

• 6190 - Lattice Radiant and Lattice Diamond: Is there any reference C source code available for embedded programming?

  C source code for embedded programming is provided in the software installation directory. For Radiant: <install_path>\programmer\embedded_source Example: C:\lscc\radiant\<Radiant version>\programmer\embedded_source For Diamond: ...

• 2340 - [MachXO2]: What is the maximum size of the SSPI Embedded SEA/SED data files?

  The SSPI Embedded data files have some overhead added to the raw data to be sent to the FPGA. At the same time the SSPI Embedded code uses a basic compression technique to try to reduce the impact of the overhead. It is difficult to determine exactly ...

• 2125 - What is the device programming time of a Lattice FPGA?

  Solution: The time to program a Lattice FPGA is dependent on several factors including configuration mode, programming speed, and device size. Some configuration modes and methods are faster than others. The complete configuration time inherently ...