6291 - CertusPro-NX: Can we use SED/SEC with “sedc_cof_i = 1” for production?

• Related Articles

• 7063 - Radiant 2023.1 and SEDC: How to use SEDC properly with reveal?

  Description: When observed at Reveal for CrossLink-NX using SoftJTAG, a timing error occurs. Solution: When using reveal with SEDC make sure that no distributed RAM is used for both Trace Signal Setup and Trigger Signal Setup like below:

• 6584 - CertusPro-NX: Does sedc_err_o and sedc_errm_o implementation of 'sticky' functionality in the Silicon itself or in some soft logic?

  Description:sedc_err_o and sedc_errm_o are implemented with "sticky" functionality. "Sticky" functionality is defined as functionality where in the setting persist even through reset. The implementation of sticky bit is implemented in Silicon.

• 6582 - All Nexus: Referring to SED/SEC User Guide for Nexus Platform (FPGA-TN-02076):In ‘Frame n’, there is significant latency between sedc_errc_o asserting and sedc_err_o asserting. What is causing this latency?

  Once an error is detected, the latency basically implies that the hardware goes into error search mode to find the type and location of the error so it can be corrected.

• 6207 - CertusPro-NX: How to inject a soft error using Radiant?

  To inject an error: (1) No need to disable SEDC. (2) Compile the design from Synthesis to PAR. Note: Do not export bitstream yet. (3) Go to Tools>SEI Editor then enable the SEI. (4) Generate SEI bitstream from Radiant's Export Files. (5) Program the ...

• 6597 - Crosslink-NX: What is the boot-up time for the Crosslink NX device?

  In datasheet, it is mentioned that "Instant-on configuration – IO configures under 3 ms". The boot-up time is based on estimation with respect to the following parts: power ramp time, config Post Power-up Test (self-test and trimming) time, bitstream ...