6101 - If i am using LDO to provide the voltage supply to FPGA, can i omit the recommended ferrite beads from the power rail design?

• Related Articles

• 1983 - Should I add a ferrite bead to the VCC core voltage supply?

  No, you do not need to add a ferrite bead between your VCC regulator output and the VCC pins on the FPGA. There are two reasons for not adding the ferrite bead, the first being that the VCC pins are less susceptible to power supply noise so they do ...

• 2655 - Platform Manager 2: Is there a low cost way to power the ProcessorPM-POWR605 off of a 5V rail?  

  Depending on the nature of the 5V rail, the ProcessorPM-POWR605 can be powered using a simple voltage divider. This very low cost solution uses a stable 5V supply with an attenuator circuit. The 3.3V rail is developed from a voltage divider using 120 ...

• 5816 - iCE40 LP/HX: Is there a list of a recommended diode for VPP_2V5 voltage like the one on many iCE40 eval boards?

  The main purpose of this diode is to drive the 3.3 V supply down to a voltage within the datasheet requirements for the VPP_2V5 pin during NVCM programming. From page 19 of our document FPGA-DS-02029-3.5, this is stated to be a minimum of 2.30 V to a ...

• 7748 - Why is there a mismatch between the hardware checklist and the evaluation board circuit design?

  Description: The customer has observed discrepancies between the design recommendations provided in the Hardware Checklist and the actual design implementation on the Lattice Evaluation Board. Reason: Hardware Checklists are developed after ...

• 1749 - Power Manager II: How do I design a PCB land pattern for Power Manager to meet UL standards?

  Designing circuit boards to meet safety certification agency requirements is a very complex subject, and the requirements you need to meet also vary by product and geographical market. For example, two common requirements for PCB design are for for ...